Table of Contents
Advertisement
6
Erasing
6.1 First confirm
recognizes
HDD ). See
6.2 Check if the voltage of connector which connected to HDD is correct or
not.( Yellow: +12V <-> Red: +5V).If no, change the power module. See picture
below.
6.3 If failed, check IDE cable/connector (40 pin) of HDD device whether assembly
/ connecting properly or not.
6.4 If not, connect it well and try again
6.5 If yes, remove the HDD from the set and connect it to a PC to check if the PC
can recognize it or not.
6.6 If the PC can recognize it ,the format it on the PC and put it back to the set,
then excute erase function again.
6.7 If not, replace / change another new HDD.
6.8 If still Failed try replacing the Main Board.
3-12
( HDD ) Failure
that it is a HDD Failure by using the Timer ( If it
the HDD ) and Erase Function ( Format the
Picture below
(Seagate screen test)!
Advertisement
Table of Contents
