Zanussi DF47/51FF Instructions For The Use And Care page 9

Before carrying out this instruction make
sure that you:
* Disconnect the appliance from the mains
supply.
* Remove all food and store in a cool dry
place.
* Remove all shelves and other loose items.
Gently lay the appliance on its back with the top
held away from the floor by at least 30cm (12"),
(use a stool or something similar) see Fig. 3.
Remove the bottom door by lifting it slightly
and carefully sliding it down off the centre
hinge (7) see Fig. 5. Remove centre hinge and
washers (where fitted) by taking out the 2
securing screws (8). Access to the outer screw
can be gained by inserting a screwdriver
through the hole in the body of the hinge, after
removing the plastic cap (9). Pull the hinge
down out of the top door. The top door can then
be removed by carefully sliding it down off the
upper hinge pin. Remove the blanking plate (10)
by taking out 2 screws (11). Refit the plate and
screws on the opposite side.
the small foot assembly. The small foot (2) can
now be removed by removing screw (3), in
order to remove the large foot/hinge assembly
(4), screws (6 and 14) should be removed
Unscrew the upper hinge pin (13) see Fig. 6
(using a screwdriver if necessary) and transfer it
to the opposite side).
making sure that the spacer (15) is retained with
the assembly.
Pull out the lower hinge pin (16) which may
have come away with the hinge blade or
remained in the door. Do NOT lose the
washer(s) (5) (where fitted).
Refit the top door by carefully sliding it onto the
upper hinge pin.
Turn the centre hinge (7) around from its
illustrated position and transfer to the opposite
side. Partly tighten one of the screws (8) in the
outside position. Gently press the hinge up into
the top door (refit any spacing washer(s) (5) on