Zanussi DF47/51FF Instructions For The Use And Care page 10

the top side of the hinge, to position the top
door at the correct height. Then slide the hinge
onto the screw (8). Place the second screw (8)
tighten both screws to secure the centre hinge to
the cabinet.
Refit the bottom door by carefully sliding it
onto the centre hinge pin. Ensure that washer(s)
(5) see Fig. 4 (if originally fitted) is/are on the
lower hinge pin (4), then push the pin (rounded
end) into the bush at the bottom of the door on
the side opposite to its original position.
Taking care not to press down on the door. The
large foot/hinge assembly should be transferred
over to the opposite side of the cabinet and
screws (6 and 14) moved over to their new
positions in the hinge foot see Fig. 4. It is
important that the spacer (15) is retained with
screw (6) in the channel between the base of the
product and the foot/hinge assembly when
screwing the foot/hinge assembly into its new
position.
Refit the small foot, its screw entering the hole
furthest from the cabinet front on the flat
portion of the base.
Then replace the level'adjuster (1).
Stand the appliance upright.
Using a pocket knife blade or a similar
instrument, carefully prise out the plastic plugs
from the alternative handle positions on the
opposite sides of the doors. (Protect the
paintwork from damage with masking tape or
other suitable material between the blade and
the painted surface).
Transfer the handles to their new positions and
push the plastic plugs into the vacated screw
holes.
Remember finally to carefully level the fridge/
freezer by means of the level adjusters (1) in the
feet - see page 7 in this instruction book.
9