Fostex XR-3 Owner's Manual page 25

<Example> Mixing Tracks 1, 2, and 3, then ping-pong recording to
Track 4
[Tj
Set the METER SEL switch to "TAPE."
f~2~l Press the PLAY button to play back the tape.
|~3~l
Use the Track 1-3 GAIN controls to adjust the track playback level.
|~4l
Locate the beginning of the tape.
(~5~l Turn the Auto Bounce switch ON. (Its LED will light up.)
6
Turn the REC SEL button 4 ON.
~
7
}
Set the METER SEL switch to "L/R."
8
Press the REC button to start ping-pong recording.
Use the Auto Bounce LEVEL dial to adjust the level of the entire track. You can check the
level of the signal to be ping-pong recorded with the right-most (0 Bounce) of the level
meters.
To ping-pong record to other tracks, refer to the steps above and set the corresponding REC
SEL button.
(-;
-
\
< Notes on the Auto-bounce function>
When the Auto Bounce switch is on, you can select only one of four tracks. That is, only
one REC SEL button will function.
The other thing you should note is that if a track has been selected for ping-pong
recording, the selected REC SEL button will be cancelled when you turn the Auto
Bounce switch OFF. In this case, you need to set the REC SEL button again.