Sony HCD-DP900P Service Manual page 20

HCDDP900D
DVD SECTION
Note :
1. DVD Block is basically designed to operate without adjustment.
Therefore, check each item in order given.
2. Use HLX-504 (J-6090-088-A) or HLX-505 (J-6090-089-A)
unless otherwise indicated.
3. Use an oscilloscope with more than 10MΩ impedance.
4. Clean the object lens by an applicator with neutral detergent
when the signal level is low than specified value with the
following checks.
Video Level Adjustment (MB BOARD)
Purpose
This adjustment is made to satisfy the NTSC standard, and if not
adjusted correctly, the brightness will be too large or small.
75 Ω
set
J601
VIDEO OUTPUT
Procedure:
1. Connect oscilloscope to VIDEO output.
2. Load a disc (HLX-504 or HL-505) playback.
3. Adjust the RV501 to attain 1.0±0.1Vp-p.
(WHITE 75%)
S-terminal Output Check
Purpose
Check S-video output.
set
G
G
J602
S-VIDEO OUTPUT
Procedure:
1. Connect oscilloscope to S-VIDEO out. (S-Y teminal)
2. Load a disc (HLX-504 or HL-505) playback.
20
Oscilloscope
1.0 ± 0.1 Vp-p
Oscilloscope
75 Ω
3. Confirm that the S-Y level is 1.0 ± 0.1Vp-p.
4. Connect oscilloscope to S-VIDEO output. (S-C teminal)
5. Connect that the S-C burst is 286 ± 50mVp-p.
Adjustment Location
MB BOARD (SIDE A)
RV501
IC503
VIDEO LEVEL
Adjustment
CN008
CN404
1.0 ± 0.1 Vp-p
286 ± 80 mVp-p
CN011
IC103
CN103