Table of Contents
Advertisement
switched on a rinse cycle to remove the
foam.
Add less detergent for the next
Note:
washing cycle with the same load.
Removing laundry/switching
off the appliance
Open the washing machine door
1.
and remove the laundry.
Set the programme selector to Off.
2.
The appliance is switched off.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Leave the washing machine door
■
and detergent drawer open so that
any residual water can dry away.
Always wait for the end of the
■
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
If the display panel goes off at the
■
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
H
Sensors
A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum. ~ Page 26
Sensors
en
21
Advertisement
Table of Contents
