Starting The Cycle; Child Lock; Selecting A Different Cycle; Pausing/Adding A Garment To The Cycle - Bosch WAT28400TC Use And Care Manual

Starting the cycle

Touch the Start/Pause button. Indicator lamp lights up
and the cycle starts.
NOTICE: If you want to protect the cycle against
inadvertent adjustment, select the child lock.
~ Child lock; Page 24
During the cycle, the display field indicates the "Finish at"
time and, after starting the washing cycle, the cycle
duration and the symbols for the cycle progress.

Child lock

You can secure the washer against inadvertent changing
of the set functions. To do this, activate the child lock
after cycle start.
To Activate/Deactivate, touch and hold Temperature and
Finish in buttons for approximately 3 seconds. The
symbol appears in the display.
lit steady: The child lock is active.
D
▯
blinking: The child lock is active and the cycle
D
▯
selector has been adjusted. To prevent a cycle
interruption, set the cycle selector back to the initial
cycle. The symbol lights up again.
NOTICE: The child lock can remain activated until the
next cycle start even after switching the machine off.
Then you must deactivate the child lock before cycle
start and if necessary activate it again after cycle start.

Selecting a different cycle

If you have inadvertently started the wrong cycle, you can
change this as follows:
Touch Start/Pause.
1.
Select another cycle.
2.
Touch Start/Pause. The new cycle starts from the
3.
beginning.

Pausing/Adding a garment to the cycle

Pausing the wash cycle can be useful for several
purposes.
e.g. for soaking ~ Soaking; Page 29
Touch Start/Pause. A
load will soak in water until continued by touching
Start/Pause.
For adding a garment after the cycle begins.
Touch Start/Pause.
1.
Open door carefully and add or remove laundry item.
2.
Note: You can do this as long as the Start/Pause
indicator flashes and it is safe to do so.
Close door.
3.
Touch Start/Pause.
4.
The cycle continues.
NOTICE: If the cycle is paused but the door will not
unlock it could be for safety reasons (high water level,
water temperature or drum speed).
24
appears on the display. Wash

Cancel cycle

For cycles with a high temperature:
Touch Start/Pause.
1.
Cool the laundry off: Select Rinse.
2.
Touch Start/Pause.
3.
For cycles with a low temperature:
Touch Start/Pause.
1.
Select Drain.
2.
Touch Start/Pause.
3.

Cycle end

End appears in the display field and the Start/Pause
button indicator lamp is off.
If this symbol
Å
detected too much foam and it automatically adds an
D
additional rinse to remove the foam.
NOTICE: Use less detergent the next time you run the
washer with the same load.
Removing laundry/switching the
appliance off
Open the front door of the washer and remove the
1.
laundry.
Turn the cycle selector to the Off position. Appliance is
2.
switched off.
Turn off the water tap.
3.
NOTICES
Do not leave any laundry in the drum. It can shrink or
▯
become discolored by the next laundry.
Remove any remaining items from the drum and
▯
rubber gasket.
Leave the front door and detergent drawer open so
▯
that any remaining water can dry.
Always wait for the end of the cycle; otherwise the
▯
appliance may still be locked. If locked, switch the
appliance on and wait until it unlocks.
If at the end of the cycle the display is not lit up, the
▯
energy saving mode is active. To see display, Touch
any button.
appears in the display, the washer has