GE JVM1950 Installation Instructions Manual page 16

Installation Instructions
To use toggle bolts:
; Spacing for Toggles More
+|++/+— Than Wall Thickness
Toggle Wings
Mounting Me Toggle
Plate ~
Bolt End
Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
rake sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION: se careful to avoid pinching
fingers between the back of the mounting
plate and the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
B3
* Read the instructions on the TOP CABINET
TEMPLATE.
* Tape it underneath the top cabinet.
* Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
ACAUTIO N: Wear safety goggles when
drilling holes in the cabinet bottom.
B4| ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
Remove the blower motor screw that holds the
blower plate to the oven. Lift the front of the blower
plate to install the blower.
Blower g
Motor Screw 73 Blower Plate
LE
Cx
As
Z
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
Rotate blower unit counterclockwise 180°.
Before Rotation After Rotation
< ccm
Gently remove the wires from the grooves.
Reroute the wires through grooves on other side
of the blower unit.
Before Rerouting After Rerouting
Wires Routed Through Left Wires Routed Through Right
Side
Side
16