Advertisement
uPASS Reach | quick reference guide
Safety precautions
The following safety precautions should be observed during normal use, service and repair.
All shields of the mandatory shielded cable shall be connected with safety ground.
•
The uPASS Reach may only be installed and serviced by qualified service personnel.
•
Disconnect the power supply before removing or installing any parts.
•
To be sure of safety, do not modify or add anything to the uPASS Reach other than mentioned in this installation
•
guide or indicated by NEDAP N.V.
Mounting instruction
The uPASS Reach can be mounted to any surface, including directly to metal. Locate an appropriate position. Use the
upper two keyholes (K) to mount the reader. Open the service cover to secure the reader using the two lower mounting
positions (L). See the picture below for details about the dimensions and the locations of the mounting positions.
200mm (7.87"
service cover
Opening the service cover
The service cover can be opened to access the connections (including the USB connector) and view the LED indicators.
Open the screws on the bottom of the device to unlock the service cover. Once the service cover is unlocked, lift it off.
Make sure the screws are completely opened (and closed when placing the cover back on).
)
47mm (1.85")
108mm (4.25")
K
L
∅4.5mm
(.17")
63mm (2.48")
4.5mm (.17")
∅5mm
(.20")
2/6
Advertisement
