Page 23
All the contents of this Guide have been checked carefully. If there are any printing errors OR misunderstanding, please contact with Midea Customer service team. NOTE: It will be compiled into the new version of the guide without any notice if involve the technical...
Thank you for choosing Midea! Please read this user manual be carefully before start use this new appliance. To ensure that you know the operate knowledge and understand more about the product features and functions in a safe way. CONTENTS...
SAFETY INSTRUCTIONS Intended Use The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance. Please check the packaging and appliance on arrival to make sure everything is intact to ensure safe operation. If you find any damage, please contact the retailer or dealer.
Page 26
Safety Instructions Please carefully read and properly keep this manual. If you pass this appliance to the third party, please ensure to include this manual at the package. To avoid the product damage or serious personal injury, please ensure to follow the instructions to install or use the appliance.
Page 27
Safety Instructions • Please use the floor washer detergent produced by our company and the manufacturer approved by us. Do not add other solutions to avoid generating toxic and harmful gases. If electric leakage, motor over-temperature, abnormal noise, peculiar smell or weak suction is found during use, stop using it immediately and contact to our customer service center.
Page 28
Warning • Read the manual before use • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
SPECIFICATIONS Product Model VCWX6 Adaptor input 100-240V~50-60Hz 0.5A Power 190W Voltage 22.2V Charging Voltage 25.0V Battery Type 22.2V 2.5Ah 55.5Wh Net Weight 3.9kg Product Size 290x240x1190mm...
PRODUCT INTRODUCTION Product Overview Mode ON/OFF Brush-roll self-cleaning Handle Clean water tank release button Clean water tank Waste water tank Waste water release button tank handle Waste water tank Brush front cover Brush-roll...
Page 31
Description of LED Power mode ON/OFF Brush-roll self-cleaning Accessories List Base x 1 Adapter x 1 Cleaning Manual x 1 Accessory Cleaning brush x 1 rack x 1 fluid x 1 Accessories Description 1. Cleaning brush • A hair brush at one end, which is used to clean stubborn dirt attached to the waste water tank and pipes below.
Page 32
Accessories Description 2. Accessory rack • Insert the accessory rack protrusion against the base recess. • Used to store brush-roll, cleaning brush and filter. Cleaning brush Brush-roll Filter Recess (both left and right) 3. Base • Used to store the floor cleaner and to be used in conjunction with the self-cleaning function of the cleaner.
OPERATING INSTRUCTIONS Preparation for Use Installation Removal Insert the end of the handle into the port To remove and store, find the round hole on of the main unit in the vertical direction the back of the unit, insert a screwdriver or until there is a click sound, which indicates other tool into the round hole to the bottom, that the installation is successful.
Page 34
Filling clean water tank Attention Only the clean water tank needs to be filled. 1. Put the machine in upright state, hold 2. Open the cover of the clean water tank, down the release button of the clean pour tap water into the tank, and then water tank with one hand, and remove put on the cover.
Page 35
Clean and operation 1. Step on the brush-roll cover and pull the handle to be 'Standby mode'. 2. Turn the machine with Power button. 3. Standard mode by default; press the (There will be a 3s delay when the 'Mode' button to switch between 'TURBO' machine is switched o ;...
Page 36
Upright and Pause When you step on the brush and put the handle upright in the working state, the machine stops working and enters standby mode; if there is no operation within three minute of standby, the machine will enter the shutdown state.
Page 37
Self-cleaning Place the machine at the base before start use the "brush-roll self cleaning" function. Press the "Self-clean" button and hold in 3 seconds, it will start the "self-cleaning" fucntion. Please clean the waste water tank after used in everytime. This is normal if the water left at the base after use the self-cleaning function, please clean up the base in time.
WASTE WATER DETECTION ALARM If the waste water tank FULL and the float block at the suction port, the 'Self-Clean' LED flash in Blue. Ensure to clean the waste water tank everytime. Float LED Instructions Attention 1. The machine must not be tilted so much that the brush is lifted o the ground, as this will cause waste water to be sucked in by the vacuum motor and then sprayed out and back onto the ground.
Page 39
Machine Status ON/OFF LED Mode LED Self-Clean LED Standard mode Display the remain battery Blue LED level always ON Turbo mode High Blue LED flash Fast suction mode High Self-cleaning Blue LED always ON Abnormal reminder Blue LED flashes and goes out after 10 seconds Charging (adapter Blue LED always ON...
CLEANING WASTE WATER TANK Attention 1. Cut o the power supply and allow the machine to stop working before cleaning the waste water tank. 2. Scrub with water or a neutral detergent; always wring out the cleaning cloth before scrubbing and do not allow water to penetrate inside the electrical components of the machine.
Page 41
5. Open the filter holder, and take out the 6. Rinse with clean water after taking it out, sponge from the filter. dry it thoroughly and put it back into the waste water tank as it is. Cartridge Upward Cleaning Filter Filter support Drying...
CLEANING FRONT COVER OF BRUSHROLL Attention 1. If any residual stains are found on the spout, wipe with a damp rag and do not rinse with water. 2. It is recommended to clean and dry the roller brush cover and brush after each use to keep it clean and tidy.
Page 43
5. After self-cleaning, if there is any residual stain on the nozzle, please wipe it with a damp cloth, and do not rinse with water. Nozzle 6. After cleaning, hold the handle of the roller brush with your hand, align the other side of the roller brush with the right cover, then put the handle end into the slot;...
TROUBLESHOOTING Please check the following table in case of any abnormal conditions when using the product. Problem Possible cause Solution The brush-roll is entangled Clean the brush-roll ● withhair and other objects The waste water tank is full Clean up the waste water ●...
Midea may constitute trademark infringement or unfair competition in violation of relevant laws. This manual is created by Midea and Midea reserves all copyrights thereof. No entity or individual may use, duplicate, modify, distribute in whole or in part this manual, or bundle or sell with other products without the prior written consent of Midea.
Need help?
Do you have a question about the VCWX6 and is the answer not in the manual?
Questions and answers