Using Pc Cards; Card Drive Assignment - Sharp PT-9000 Operation Manual

4.12
OPTIONS
When you use a PCMCIA hard disk card, it is recommended that
you run the system using AC power through an optional AC
adaptor CE-901 V or CE-902V, since the hard disk card requires
more power to be supplied by the PT-9000.
Using PC Cards
To insert a card:
1.
Open the appropriate card drive on the side panel of the unit by
pushing down the catch and levering the cover downward.
NOTE
You can remove the card slot hinged cover by levering it
downward. Replace the card slot cover when the card slot is not in
use or when you carry the unit.
2. Insert a card firmly until its connector fully mates to the connector
in the slot. If the card is installed completely, the eject button on
the side of the card drive pops out.
To eject a card:
Push the eject button on the side of the card drive, then the card
pops out. Pull the card and remove it.
CAUTION
When you use a SRAM card, be sure to install a battery in the
card. If the battery is not installed or it is discharged, the data
stored in the card will be lost when the unit is turned off.
Card Drive Assignment
The drive assignment of the installed card varies according to the
type of card.
DRIVE ASSIGNMENT
PC
CARD TYPE CARDSLOT1 CARDSLOT2
Hard Disk Card
E F
SRAM Card G,H
I,
J
Flash RAM Card
K L
The drive H and] are available when you divide the capacity of
SRAM card into two drives.