Table of Contents
Advertisement
Operating peripheral equipment using the remote control
Programming Without A Code(Whenthecodeis notknown)
This procedure searches all codes and is called the "sequence method."
32
]VNID_O
RECALL
MUTE
GUIDE
0
0
0
0
I®
® ®1
I®®®1
R_
pLAy
FF
PAUSE
STOP
REC
nn c_n r'_
ASPECT
TVNCR
VC_$CH
1
_
2
Turn the component off.
6
Confirm that the external component is plugged in and on.
Press POWER and OK together,
for at least 5 seconds.
After 5 seconds, all the illuminated
mode keys will begin to flash.
Release the POWER and OK key.
Press the mode key.
The mode key will illuminate
steadily, all others will go out.
Press to move forward to the next
code, or to move backward.
Press the Remote Control _
to test the component. If the
procedure was successful, the component will turn on.
Note:
Repeat the above steps until the component code is found. It may
take many attempts before the correct code is found.
7
After the code is found, press OK to
store the code.
Note:
The step and set mode will start from the current device (not the
beginning of the list, except for the first time).
Advertisement
Table of Contents
