Loading The Film Cartridge - Sankyo SUPER CME666 Instruction Manual

7) LOADING THE FILM CARTRIDGE
Push the button located on the top of back side of the camera in order to
release the side cover lock . Open the side cover and install the film car-
tridge. To load the cartridge properly , match the cut-out on the cartridge
with the gu ide pin on the right edge of the film cartridge compartment
and press the cartridge until it clicks into position . After determining that
the film cartridge has been installed properly, close the side cover. This
simple procedure of film cartridge loading automatically sets the exposure
system to the required ASA speed rating . If the film is not transported the
first time,
b
, h ,
' ! ' ! •
6
•
3 1 ,. d
, h
d tb
.
;
I f
sr I
use a new cartridge .
A. Film Run Indicator
The green lamp on the bottom edge
of the viewfinder field will flicker
when the film is being transported
properly. A defective film cartridge
or improper loading are indicated if
the lamp fails to flicker. In such a
case, replace the cartridge or re-Ioad
it properly . When the entire length
of the film has been exposed, the
indicator lamp will cease
to
flicker
(the end of the film is indicated when
the lamp either goes off or stops
flickering).
13