Table of Contents
Advertisement
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button P until the digital
display H jumps to œ:‹‚.
4. Press button P until the displayed
time corresponds with your
requirements.
5. Press START button @, timer
programming is activated.
6. To delete the preselected starting
time, press the button P until œ is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
value ‹:‹‹ is indicated on the numerical
The programme has ended when the
display H.
Operating the appliance
Switching off automatically
after the end of
the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
Automatic disconnection
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press and hold down the START
button @.
4. Rotate programme selector 8
until ˜:‹... s indicated on the digital
display H.
5. Release button.
The factory set value ˜:‹‚ is lit on
the digital display H.
To change the setting:
1. Rotate programme selector 8 until
the required value is indicated on the
digital display H.
2. Press START button @.
The set value is saved.
en
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
23
Advertisement
Table of Contents
