MSI G31M4 Series Manual page 16

M S-7527 M ainboard
Installing Memory Modules
1. The memory module has only one notch on the center and will only fit in the right
orient ation.
2. Insert the memory m odule vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the DIMM slot. The plastic
clip at each side of the DIMM slot will automatically close when the memory module
is properly seated.
Important
You can barely see the golden finger if the memory module is properly inserted in
the DIMM slot.
3. Manually check if the memory m odule has been locked in place by the DIMM slot
clips at the sides.
Important
- DDR2 memory modules are not interchangeable with DDR and the DDR2
standard is not backwards compatible. You should always install DDR2
memory modules in the DDR2 DIMM slots.
- In Dual-Channel mode, make sure that you install memory modules of the
same type and density in different channel DIMM slots.
- To enable successful system boot-up, always insert the memory modules
into the DIM M1 first.
En-8
Notch
Volt