Table of Contents
Advertisement
CREATING PROGRAMS II (IN THE SURROUND MODE)
Only the DELAY TIME and REAR EQ parameters can be controlied in
the SURROUND mode. (DELAY TIME cannot be controlied in the DOLBY
3CH LOGIC and STUDIO programs}.
O
|
. Select the frequency band with the FREQUENCY
(+, ~
. Set to the desired level with the LEVEL keys.
. Carry out the same procedures as in 1 and 2 for other
. Select SURROUND
on the main unit or with the
remote control unit.
it's also possible to call up a program using the UP/DOWN. svarzches
on the main unit.
* If the processing indicator and equalizer ON indicator aré
turn them on.
then
. Press the DELAY L+R/L/R key.
Each time you press it, it will change from L and R, to 4st .. and
* Inthe DOLBY PRO LOGIC SURROUND and THEAT!
Land R are adjusted independently, and in the in the 5
and SIMULATED SURROUND programs L and R are
the same time.
you reach the desired value, and then release.
Pressing both + and — keys together takes you back to tre
cardard
(STD) value.
. Adjusting the REAR EQ (Adjustment of FRONT is not
possible)
bands.
* REAR is not used with DOLBY 3CH LOGIC, so EQ aciusc~ ent is
not possible.
OUTPUT
INPUT
FRONT L
Lo
© FRONT R
SURROUND
© CENTER L
PROCESSING |~___ T a
~O CENTER R
eee
t
fi
°
an 7 band EQ
+
REAR
L
|
{7 bend
EQ};
REAR R
a
ai
t
22
<ARB1203>
* in SURROUND, the standard values are all flat (0).
* Pressing the + and — keys together returns the equalizer s@merns
to the standard {STD) values.
Advertisement
Table of Contents
