Smith 190451 Quick Start Manual

WARNING: RISK OF PERSONAL INJURY AND CHEMICAL EXPOSURE DUE TO RUPTURE AND/OR HIGH
PRESSURE DISCHARGE OF LIQUID CHEMICALS. Read instruction manual and chemical manufacturer's instructions
before use.

1. Connect Hose To Tank

IMPORTANT: Do not attempt to heat or
alter Hose, Hose Nut, or Adapter prior
to assembly.
. Insert Hose Dip Tube into Tank.
A
(See Figure A).
B. Align tabs on Hose Adapter with slots in
Tank, and push Hose Adapter into Tank
until it stops. (See Figure B).
C. Slide Hose Nut down to tank and turn
clockwise to tighten. (See Figure C).
NOTE: Do not use tools to tighten hose nut.

2. Connect Shutoff to Hose

Screw on Shutoff to end of Hose. Tighten securely.
(See Figure D).

3. Connect Nozzle to Wand

Place Check Valve inside of Brass Wand. Then place
brass Teejet® Nozzle and Nut on top and screw into
place. (See Figure E).

4. Connect Wand to Shutoff

Align Wand Assembly to Shutoff and tighten Nut
using a 13/16" wrench. (See Figure F).
QUICK START GUIDE
SETTING UP YOUR CONCRETE R301 SPRAYER
Hose
Nut
Wand Assembly
Figure F
190451
Adapter
Tab
Slot
Figure A
Shutoff
Brass Wand
Check Valve
Nozzle Tip
Nut
O-Ring
Figure B
Hose
Figure D
Figure E
Shutoff
Figure C