Little Giant Ladder WingSpan Wall Stand Off Instructions

®
To assemble, hold down the spring pins
and slide the arms into the rung bracket
until the spring pins lock into place.
Swing the clamp around and hook it into
the open slot in the rung bracket, then
tighten the clamp onto the rung. If the
clamp will not reach the slot, loosen the
clamp all the way, and then try again.
Make sure the WingSpan
before each use.
If you need any assistance with these instructions,
please call our Customer Experience Team at
shown without arms
Make sure the clamp is swung out of the
way, and the outer assembly on the
ladder is extended at least one rung.
Your WingSpan wall standoff is now
ready to use
is secure
TM
INSTRUCTIONS
800-453-1192.
Slide the rung bracket onto the top outer
rung as shown above. The rung bracket
should sit at 90 degree angle as shown
in the image below.
Components
Clamp
Arms
Rung bracket
Spring pin
Correct
Incorrect