Advertisement
Quick Links
READ THESE INSTRUCTIONS COMPLETELY BEFORE YOU START. IF YOU DON'T
UNDERSTAND THESE INSTRUCTIONS, PLEASE CALL 800-453-1192 FOR ASSISTANCE
Procedure for installing the Fixed Foot on Little Giant Ladder Systems Extension ladders.
1. Failure to comply with all instructions may result in serious injury.
2. Make sure this kit is compatible with your ladder. If you have any questions concerning
the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for
assistance.
3. Before installing this kit, identify all kit components. If any components are missing or
damaged, please contact Customer Care. Do not substitute any components.
4. Inspect the ladder before installing this kit. Repair or replace any damaged or missing
ladder parts before using the ladder. Use only Little Giant Ladder Systems repair or
replacement parts. If you are unable to repair it, discard the ladder.
COMPONENTS IN KIT
NOTE: IF ANY OTHER PART OF THE LADDER IS DAMAGED BEFORE OR DURING
THE PROCESS OF INSTALLING AND/OR REPAIRING, DISCARD THE LADDER OR
CONTACT CUSTOMER CARE FOR INSTRUCTIONS.
Fixed Foot
Replacement
(1) Fixed Foot
(2) Hex Head Bolt
(2) Center Nut
(4) 3/8" Washer
DO NOT USE A DAMAGED LADDER!
TOOLS NEEDED
(2) 9/16" Wrench
57774 v1 1.15 (1)
Advertisement
Related Manuals for Little Giant Ladder 31408
Summary of Contents for Little Giant Ladder 31408
- Page 1 1. Failure to comply with all instructions may result in serious injury. 2. Make sure this kit is compatible with your ladder. If you have any questions concerning the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for assistance.
- Page 2 1. Identify the feet that you will be replacing on your 2. Lay the ladder on its face to make the following extension ladder. steps easier. 9/16” Wrench 9/16” Wrench 3. Using (2) 9/16” wrenches, loosen and remove the 4. Remove (existing) foot. (2) washers, bolt and nut that are holding the (exist- ing) foot in place.
- Page 3 Side View Top View 7. Once both feet have been removed, insert the 8. Make sure that the picked plate on the foot is (new) fixed foot onto the ladder. facing (down) or the back of the ladder. (As shown in the illustration.