Yamaha PROFESSIONAL PC2002 Operating Manual page 5

Веаг рапе!
Cord Reel
|)
SIEREO МОМО
МАХАМ
SP MRIG
USED.
CAUTION то REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER HO USER SERVICEABLE PARTS INSIDE PROT LAMP SOLOERED IN PLACE.
REFER SERVICING TO QUALIFIED SERVICE PEAS
ATTENTION afin DE RÉOUIRE LE RISQUE Hi ЕЗ EON. Ms
ENLEVER LE COUVERCLE. IL NE ЗЕ TROUVE A СМТЕВЕУЯ Al
POUVANT ETRE БЕРАНЕ PAR LUSAGER. LA LAMPE, ТЄМОН EST SOUDGE EN
PLACE.SAORESSEA А UN REPARATEUR- СОМРЕТЕ!
WARNING то nebuce тне Te О OF FIRE. г сию 'SHOCK, DO мог
EXPOSE THIS APPLIANCE TO RAN ОН MOISTURI
CAUTION то ЕЕ due
FISK OF FIRE, REPLACE
чат SAME TYPE FUSE, 0
ATTENTIONS эни DE А RÉDUnE
LE RISQUE DE FEU, REMPLACE!
LUNQUEMENT PAR VW FUSLE
PRIMARY {е
7A 1250
«95,
х
US 4 Canadian models
YAMAHA
General model
These jacks can also be used as send terminals.
Ө PIN 1GND SW
Couples or decouples the canon connector earth line (pin 1, о BALANCED/UNBALANCED Switch
shield). Normally ON. In some cases where ground loops Determines which input connectors are active. In the
cause excessive hum, turning the ground switch OFF can
BALANCED
position, input signals are accepted
via the
interrupt the loop and reduce the hum. balanced Canon connectors, and in the UNBALANCED
position input is accepted via the unbalanced phone jacks.
Ө Canon Connectors (XLR-3-31)
These connectors are generally used as inputs. Pin 1 is @ MODE Selector Switch
©) Canon Connectors (XRL-3-32)
Compatible with Canon' XLR-3-11C ог switchcraft
5C-1056A connectors, these connectors are useful for send-
ing the input signal to other power amplifiers.