Table of Contents
Advertisement
5. The two deck stabilizers and the diagonal brace
which are attached to the front of the deck are
folded back over the deck for shipping purposes.
Unfold them at this time. See figure 5.
6. Slide the deck under the tractor from the left side.
You may need to angle the deck slightly to get the
braces past the front wheel.
NOTE: When attaching the cross bar, reference to the
right or left hand side is observed facing the front of
the tractor.
FIGURE 5.
7. Standing in front of tractor, remove the hairpin
clips from the cross bar.
8. Slide the cross bar to the left until the right side is
free. Drop bar down and slide to the right until
cross bar is removed from the tractor.
9. Insert cross bar through the two deck stabilizers
and the diagonal brace. See figure 6A.
10. Place a spacer on the left end of the cross bar.
Pull the bar to the right until the spacer is flushed
with the end of the bar as shown in figure 6B. Lift
assembly and slide the cross bar into one of the
holes on the left side of frame. Secure with hairpin
clip removed in step 7.
46" Deck:
Use the
rear
set of holes.
50" Deck:
Use the
forward
set of holes.
11. Place a spacer on the right end of the cross bar.
Pull the bar to the left until the spacer is flushed
with the end of the bar. Slide the cross bar into the
hole on the right side of frame. Secure with hairpin
clip. See figure 6D.
12. Move the lift lever forward to the lowest position.
NOTE: It may be necessary to pull down on the lift
links to obtain the lowest position.
FIGURE 6.
13. Lift up on the edge of the deck and hook up the
left front deck hanger to the deck using a flat
washer and hairpin clip. Make sure deck hanger
goes through the center of V-belt. See figure 7.
14. Attach the right front hanger to the deck using a
flat washer and hairpin clip.
15. Move the lift lever all the way back to the full
raised position.
9
Advertisement
Table of Contents
