G3 Ferrari G30054 User Manual page 10

PREPARATION
BATTERY LOADING
a. Open battery cover.
Load two "AAA" size batteries. Please pay attention to polarity.
b.
c. Close the battery cover.
When LCD shows battery symbol
Rechargeable batteries are not suitable for this monitor. Remove the batteries if the monitor will not be
used for a month or more to avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes, immediately rinse with plenty of
clean water and contact a physician.
SET THE USER FOR MEASURE SAVING
The device is equipped with a memory containing 120 measures.
These memories are divided in 2 groups of 60 measures each.
In case 2 persons use the appliance, you have to associate one user to
the memory group 1, and the other user to the group 2.
With device off, press button SET (8), the icon of the group flashes.
Press button M (6) to select the memory group in which save the
measure, then confirm with START/STOP.
Following measures will be saved in the group set. If the person changes, remember to change user.
CLOCK AND DATE ADJUSTMENT
1) After setting the user, press again the button SET (8) to enter Clock setting Mode.
2) The digits of the months flash. Set the month with the button M (6).
3) Press SET to pass to the days and set with button M.
4) Repeat operation for hours and minutes.
5) Confirm settings by pressing START/STOP (7).
CONNECTING THE CUFF TO THE MONITOR
The cuff is attached to the monitor when it is packaged. If cuff become
unattached, align the two plugs and four brackets of the cuff with the plug sockets and bracket sockets of
the monitor and press the cuff to the monitor until the plugs and brackets are securely attached.
WRIST CUFF and BODY POSTURE
Place the cuff around a bare wrist 1-2cm above the wrist joint on the palm side
of the wrist. While seated, place the arm with the cuffed wrist in front of your
body on a desk or table with the palm up. If the cuff is correctly placed, you
can read the LCD display. The cuff must be neither too tight nor too loose.
NOTE:
- Always measure the same wrist.
- Do not move arm, body or monitor during measure.
- Stay still and quiet for 5 minutes before measuring.
- Wait 3 minutes between 2 measurements.
Be seated with your feet flat on the floor, and don't cross your legs. Place
-
palm upside in front of you on a flat surface such as a desk or table. The
middle of the cuff should be at the level of the right atrium of the heart.
- Keep the cuff clean. If the cuff becomes dirty, remove it from the monitor and
clear it by hand in a mild detergent, then rinse it thoroughly in cold water.
Never dry the cuff in clothes dryer or iron it. Clean the cuff after the usage of
every 200 times is recommended.
,replace all batteries with new ones.
9