Table of Contents
Advertisement
Remote Commander
Here eA
alee
[3] Amplifier/TV section
Note on the @ (recording) button under [3]
SURROUND mode buttons
Equipment control button
(for the AV control amplifier)
If your recorder is of such type as pressing @ + > or @ +
ON/OFF: Turns on/off the surround mode.
"i puts it in recording mode.
MODE: Selects the surround mode.
T.(test) TONE: Outputs test tone to each speakers in
Note
succession.
The <@/B> (play) buttons (for TAPE, CD, MD or VTR 1
DELAY: Press when adjusting the delay time.
and the SHIFT button and PRESET/CH +/- buttons in
CENTER VOL +/- buttons: Control the volume of center
can function without pressing one of the FUNCTION
speaker. ( for the AV control amplifier.)
buttons in [3].
REAR VOL/TV CH +/—buttons: Control the volume of
rear speakers. (for the AV control amplifier.)
SUPER WOOFER ON/OFF button: Turns on/off the
super woofer. (for the AV control amplifier)
PHASE button: Turns on/off the phase effect. (for the AV
control amplifier)
:
:
VOL +/~ buttons: Control the volume ofthe super
woofer. (for the AV control amplifier)
CURSOR CONTROL buttons: Select a number or adjust
the level (for the AV control amplifier)
FLAT button: Flattens the equalizer curve. (for the AV
1 open the cover.
2 pboashbe nn hich
control amplifier)
DISPLAY button: Changes the display mode of AV
correct polarity.
control amplifier.
SOUND FIELD button: To select a factory preset sound
field, press this button and then select a number with
the CURSOR CONTROL buttons. (for the AV control
amplifier)
USER button: To select a user preset sound
field, press this button and then select a number with
the CURSOR CONTROL buttons. (for the AV control
amplifier)
Function buttons: Select an input source of the AV
Battery life
control amplifier
About half a year of normal operation can be expected when
MASTER VOL +/~ buttons: Control overall volume level.
using the Sony SUM-3 (NS) (size AA) batteries.
When the batteries are exhausted, the commander can no
[4] Reset button
longer operate the unit. Replace both batteries with new
Resets the commander to the initial state.
ones.
[5] Power control section
To avoid battery leakage
SYSTEM OFF button: Turns off the power of the whole
When the commander is not to be used for a long period of
system: LDP, VCR, TV, and AUDIO.
time, remove the batteries to avoid damage caused by
LDP/VTR1/VTR2/VTR3/TV/AUDIO POWER buttons:
—_pattery leakage and corrosion.
Control the power of each unit.
To avoid malfunction of the remote commander
Avoid keeping the commander under extremely hot or
humid location.
Advertisement
Table of Contents
