Table of Contents
Advertisement
How to set water hardness in order to always assure the best cleaning results
1- salt reservoir
2- rinse aid dispenser
3- detergent dispenser
4- racks system
5,6,7,8- available functions on the panel
9- filters
10- spray arms
Water hardness should be set only
before the first wash or if water
hardness has been changed
1. Ask your water supply company what the water hardness is...
German
French
English
degrees °dH
degrees °fH
degrees °eH
0 - 5
0 - 9
0 - 6.3
6 - 10
10 - 18
7 - 12.6
11 - 15
19 - 27
13.3 - 18.9
16 - 21
28 - 37
19.6 - 25.9
22 - 28
38 - 50
26.6 - 35
29 - 35
51 - 63
35.7 - 44.1
36 - 60
64 - 107
44.8 - 74.9
At first time use, the salt reservoir has to be filled independently from water hardness level (see description below in step 1 "Daily check").
Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to "soft"!)
1
Visual indicator
(depending
on the model).
Unscrew cap.
The salt level indicator lamp may remain lit
at the end of several wash cycles. If the
water hardness level falls within category
(soft), no salt is required.
- Press and hold together Programs and
- Programmes LEDs will indicate the water hardness setting.
- Press the Programs button to increase setting (when the level reaches 7, the next key press will set the level back to 1.
- Wait 30 seconds (control panel switches off) or press START/Resume button to save setting.
2. ...enter this value on
your dishwasher
3 first PROGRAM LEDs
Water hardness
lit on the panel
level
(see table of programmes)
P1
P2
P3
Soft
1
Medium
2
Average
3
Medium-hard
4
Hard
5
Very hard
6
Extremely hard
7
Fill the salt reservoir with water
before the first wash only.
(depending on the model)
Salt indicator on the control panel
The indicator lamp lights up when SALT
NEEDS TO BE ADDED.
buttons for minimum 3 seconds.
Suggestions for detergent use
Gel or Powder
(rinse aid and
Tablets
salt)
go to step 1
(see "Daily
if water is
check")
HARD extra salt
needs to be
added
(go to step 1,
"Daily check")
Add salt (never add detergent!)
min. 1.5 kg / max. 2 kg
Salt indicator on the salt reservoir cap
orange:
OK.
First time use
Water hardness level is
factory set for medium-hard
water (level 4).
Even if you use tablets which
include salt, you must still add
regeneration salt since such
detergents are not effective
enough at softening hard
water.
Daily check
Screw on the cap.
Salt residual
around the cap
need to be
removed. Some
salt reservoir have
a level indicator
integrated in the
cap (see below
how to check).
clear: NEEDS TO
BE ADDED
GB -2-
Advertisement
Table of Contents
