Whirlpool ADP 5600 PC Quick Reference Manual

Quick reference guide
PROGRAM SELECTION START/RESUME BUTTON
BUTTON Push this button to start the selected program: the
Push "Programs" button indicator lights up and goes off at the end of the
(repeatedly) until the indicator program. When the door is opened during a
of the required program lights washing cycle, the cycle is temporarely paused: the
up (see "Table of programs" Start indicator blinking. To restart the cycle close
below). the door and push Start button again.
Table of programs
P
Programs
1
AutoSensor 50-65°C
2
Quickwash 45°C
3 2)
50°C
Eco
4 3)
Antibacterial
5
Intensive 70°C
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the
appliance's automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher (1
minute process).
If the indicator flashes repeatedly, see page 6 -
chapter "What to do if ...".
Available
Loading instructions
options
Delay Recommended program for routine
Power Clean washes, with dried-on food (e.g. EN 50242).
Lightly soiled crockery, with no dried-
Delay
on food.
Delay
Normally soiled crockery.
Power Clean
Normally or heavily soiled crockery, with
Delay
additional antibacterial wash. Program
interruption (e.g. due to door opening)
Power Clean
can compromise elimination of germs.
Recommended program for heavily soiled
Delay
crockery, especially suitable for pans and
Power Clean
saucepans.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
Options and display description
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
POWER CLEAN
Thanks to the additional
power jets this option
Consumption
provides a more intensive and
Deter-
powerful wash in the lower
gent
rack, in the specific area.
1)
Litres kWh
Minutes
This option is recommended
for washing pots and
casseroles (see page 4). Press
X 7-14 1.00-1.60 70-155
this button to activate Power
Clean (the indicator lights up).
X 11.0 0.80 30
X 12.0 1.05 150
TABLET SETTING
This setting allows to optimize the cycle performances
X 13.0 1.50 115
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
X 14.0 1.55 155
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
ADP 5600 PC
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF ANY CYCLE IS STARTED.
Chart
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
5019 396 01839/B
GB -1-