Turning On/Off The Power; The Camera Status With The Led - FujiFilm instax Pal User Manual

Preparation for the camera

Turning on/off the power

1
Press and hold the power button for approximately
2 seconds.
The LED lights up, and the power turns on.
■ When turning off the power
Press and hold the power button. The LED turns off, and then the
power turns off.
The camera will automatically be turned off after 2 minutes of
inactivity (default setting). You can change the setting to "5 min" /
"OFF" in the app menu.
7

The camera status with the LED

You can check the status of the camera with the LED.
Both Fun/Link mode
LED state
White pulsing light Bluetooth connection is not established,
and battery level is sufficient
Red pulsing light Bluetooth connection is not established,
and battery level is Low
Pink light Displayed whilst taking a photo
Purple pulsing light Transferring images
Blue slow flash Updating firmware
Blue fast flash Firmware update error
Yellow fast flash The camera's internal memory or SD card
(for 3 seconds) is full. Or the number of untransferred
images* from camera to app has reached
50 photos. Connect the camera to the app
via Bluetooth and follow the on-screen
instructions to save and continue.
* You can take up to 50 photos before
image transfer to the app is required.
• When you transfer images to the app,
the image files in the internal memory
are deleted (initial setting). You can set it
to keep images in the internal memory,
however, be aware of the maximum
number of images that have not yet
been transferred.
Yellow light The battery level may be very low. If this
(for 3 seconds) continues even after charging, contact us.
Red fast flash A rise in camera temperature has been
(for 3 seconds) detected. The camera will automatically
power off after 3 seconds.
Fun mode
LED state
Blue pulsing light Bluetooth connection with smartphone is
complete
Link mode
LED state
Green pulsing light Bluetooth connection with an INSTAX Link
printer is complete
Meaning
Meaning
Meaning