Advertisement
Caution on Disassembly
Follow the below-mentioned notes when disassembling the
unit and reassembling it, to keep its safety and excellent
performance:
1.
2.
3.
. Take sufficient care on static electricity of integrated
Take out a record of the unit.
Be sure to remove
the input/output
plug from the
SA-205H/E
before
starting to disassemble
the unit.
Take off nylon bands or wire holders where they need
be removed when disassembling the unit. After servicing
the unit, be sure to rearrange the leads where they were
before disassembling.
circuits and other circuits when servicing.
REMOVAL
Cabinet
1. Open the turntable
compartment* 1
2
Front pane!
Main P.W.Board
Turntable
compartment *3
. Move forward the
tonearm
*2
2. Screw
Tonearm block
*1: Opening
the turntable
compartment
is possible
by the
following two ways;
e
Connect the input/output plug to the Receiver (SA-
205H/E),
turn
on
the power
switch
and
push the
open/close button to open the turntable compartment.
e
Loosen
the screw at the loading motor
by using a
Phillips screwdriver
at the rear of the unit and then
shift the motor so that the turntable compartment can
be opened manually, See Fig, 4—2.
*2: Moving forward the tonearm is possible by the following
two ways;
e
Connect the input/output plug to the Receiver (SA-
205H/E),
turn
on
the
power
switch
and
push the
forward button to move forward the tonearm.
e
Apply
DC
10V
to the socket CNS104
so that the
tonearm is moved forward, See Fig. 4—2.
*3: When
removing
the turntable
compartment,
be careful
not to put undue
force to the door switch
(SW302).
Main P.W.Board
DISASSEMBLY
Cabinet
a
Ne
rc
a
Front Panel
(B) x1
EC 63 x
5mm
SS
en oe
|
f a
Turntable Compartment
Turntable
Compartment
" Figure 4—2
Figure 4—3
Top View
| Phillips Screwdriver
iat Push
Advertisement
