Kingfisher MEAP43 Original Instructions Manual page 13

Kickback is the result of tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper
precautions as given below:
1. In case of kickback (rebound), release the throttle trigger
immediately and hold the product handle with both hands
to avoid losing control of the machine and causing danger.
2. Maintain a firm grip, with thumbs and fingers encircling
the product handles, with both hands on the machine and
position your body and arm to allow you to resist kickback
forces. Kickback forces can be controlled by the operator, if
proper precautions are taken. Do not let go of the product.
3. Only use replacement drilling tool specified by the
manufacturer. Incorrect replacement drilling tools may cause
drill breakage and/or kickback.
4. Ensure yourself that there are no loose objects lying
around in the working area.
5. Eliminate high grass, bushes etc. from the immediate
working area. They might be winded up by the rotating drilling
tool and block it.
6. Take especially care, if the ground contains many stones
or roots. An unattended stalling of the drilling tool might easily
cause an accident.
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the
time of operation, use low-vibration and low-noise operating
modes as well as wear personal protective equipment.
Long-term exposure to noise can result in permanent hearing
impairment. So always use approved hearing protection.
Take the following points into account to minimize the vibration and
noise exposure risks:
1. During a working day, you shall take frequent and adequate
breaks to prevent damage from vibration and damage to the
ears.
5063022059833_MNL_EN_V06.indd 13 5063022059833_MNL_EN_V06.indd 13
13
27 Sep 2023 17:06:05 27 Sep 2023 17:06:05