Raider RD-WH06 User Manual page 9

a clean soft cloth with proper glass detergent.
• Use neutral detergent to clean the welding shell and
headband.
•.Replace outer and inner protection plates periodically.
• Don't immerse the lens in water or any other liquid.
Never use abrasives,solvents or oil based cleaners.
• Don't remove the auto-darkening filter from the helmet.
Never try to open the filter.
WARNING
• This Auto-Darkening filter welding helmet is not suitable
for laser welding & Oxyacetylene welding.
• Never place this this Helmet and Auto-darkening filter
on a hot surface.
• Never open or tamper with the Auto-Darkening Filter.
• Before operating, please make sure if the
function-setting switch
"WELDING"/"GRINDING", or not. This Auto-darkening
filter welding helmet will not protect against severe
impact hazards.
• This helmet will not protect against explosive devices
or corrosive liquids.
• Don't make any modifications to either the filter or
helmet, unless specified in this manual. Don't use
replacement parts other than those specified in this
manual.
• Unauthorized modifications and replacement parts will
void the warranty and expose the operator to the risk of
personal injury.
• Should this helmet not darken upon striking an arc, stop
welding immediately and contact your supervisor or your
dealer.
• Don't immerse the filter in water.
• Don't use any solvents on filters' screen or helmet
components.
• Use only at temperatures: -10°C ~ + 55°C (14°F ~
131°F )
set the suitable location
• Storing temperature: - 20°C ~ +70°C (-4 °F ~ 158°F )
• Protect filter from contacting with liquid and dirt.
• Clean filters' surfaces regularly; do not use strong
cleaning solutions. Always keep sensors and solar cells
clean using a clean lint-free tissue/cloth.
• Regularly replace the cracked/scratched/pitted front
cover lens.
Severe personal injury could occur if the user fails to
follow the aforementioned warnings. And / or fails to
follow the operating instructions.
Auto-darkening filter does not darken or flickers
• Outer or inner protection plate is soiled or damaged.(To
clean or replace the plate.)
• Sensors are soiled.(To clean the sensor' surface.)
• Welding current is too low.(To press "SENSITIVITY"
select "High")
• Slow response
Operating temp is too low (do not use at temperatures
below -10°C or 14°F).
• Poor Vision
• Front /inside cover lens and/or filter lens are soiled
(change lens)
• There is insufficient ambient light
• Shade number is incorrectly set (reset the shade
number)
• Welding Helmet Slips
Headband is not adjusted properly (readjust headband)
WARNING!! Operator must stop using the auto–
darkening filter welding helmet immediately if the above-
mentioned problems cannot be corrected. Contact the
dealer.
Product warranty
• The manufacture's sole obligation under this warranty
is limited to making replacement of repairs,or refund of
the purchase price for the products with defects.
9