Table of Contents
Advertisement
Video/Audio Scart lead
Link both VCR's by using a Scart lead as shown in the diagram. Connect the EURO AV2 IN of recorder @ to the
EURO AV socket or to RCA AUDIO/VIDEO OUT sockets of recorder ®. If the second VCR ® has no Scart socket
but has an RCA AUDIO/VIDEO output then use a corresponding adapter cable. In this example your Mitsubishi VCR
@ is being used as the recording device.
1.
Onthe remote control press the JOG G button un-
til the external channel L2 (EURO AV2 IN) shows
on the Mitsubishi VCR ©.
2.
Start playing on the other VCR ©, then press the
REC button on the Mitsubishi VCR @.
An external channel must not be selected on
—s
the playback VCR (®) especially when the
recording VCR (@) is connected via a Scart cable.
Alternatively you can connect your new VCR up to
record from other equipment:
-A satellite receiver
-Video camera
Connect your new VCR to a Satellite receiver or Video
camera by using a scart cable or a scart to phono cable.
(For further information on connections, see page 5.)
24
Tip:
If you want to have a permanent
connection between two VCR's, itis best
to use a Scart cable.
=
Editing control
This feature is ideal for editing commercials
while
recording.
During recording, press the PAUSE button.
By using the SHUTTLE &3 or @ buttons, position the
tape at the beginning of the commercial.
Press the
PAUSE button when the picture you wish to start recording
is located.
After approximately 3 seconds, the screen
will return to the picture you wish to record and record
pause mode will be resumed.
Press the PAUSE button
when
the commercials
are finished
to commence
recording.
Advertisement
Table of Contents
