Advertisement

Quick Links

ADG 7566
On button
Off button
Programme selection button
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add rinse aid
Add regeneration salt
only add regeneration salt immediately
before starting a wash programme.
Programmes
Pre-Rinse
Quickwash
1)
Normal
Normal
Intensive
1)
Reference programme for energy label in compliance with
EN 50242 regulations;
2)
Refer to "User instructions";
Whirlpool is a registered trademark of Whirlpool USA
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme chart
Loading instructions
cold
Crockery to be washed later.
40°C
Lightly soiled crockery with no dried-on food.
50°C
Normally or heavily soiled crockery.
65°C
Normally or heavily soiled crockery.
Recommended programme for heavily soiled
70°C
crockery, especially suitable for pans and
saucepans.
Options
"Delayed start" button
The wash cycle can be programmed
to start after 3-6-9 hours.
Then press the Start button.
The wash programme will start at
the set time.
"Half load" button
This function can be used with any
programme. The indicator lamp
switches on. The wash cycle is
activated for the upper or lower rack
only.
2)
Detergent
A
B
-
-
X
-
X
X
X
X
X
X
3)
Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.
(We reserve the right to make technical modifications)
GB
3)
Consumption
Litres
kWh
Minutes
4.0
0.03
14
10.0
0.65
30
13.0
1.05
110
13.0
1.45
90
20.0
2.00
125
5019 396 91138
WH/I/FD/GB

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool ADG 7566

  • Page 1 - above or below 15°C - as well as water hardness and power supply voltage, etc. Refer to “User instructions“; 5019 396 91138 Whirlpool is a registered trademark of Whirlpool USA (We reserve the right to make technical modifications) WH/I/FD/GB...
  • Page 2: How To Use The Appliance

    How to use the appliance Further indications are given in the single chapters and in the user instructions. Open the door, Press the ON button. switch on the appliance Large compartment A: With each wash cycle. How to fill the detergent dispenser Small compartment B: For programmes with pre-wash only.
  • Page 3 Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long- stemmed glasses.
  • Page 4 What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem Cause Remedy The appliance is not •...
  • Page 5 INSTRUCTIONS FOR USE BEFORE USING THE DISHWASHER/ CONNECTIONS ELECTRICAL CONNECTION PRECAUTIONS AND GENERAL RECOMMENDATIONS HOW TO FILL THE SALT CONTAINER HOW TO FILL THE RINSE AID DISPENSER HOW TO FILL THE DETERGENT DISPENSER CARE AND MAINTENANCE...
  • Page 6 BEFORE USING THE DISHWASHER/ CONNECTIONS 1. Removing the packaging and controls: 4. Electrical connection: After unpacking, make sure that the dishwasher is • Closely adhere to local Electricity Board undamaged and that the door closes correctly. If in regulations. doubt, contact a qualified technician or your local •...
  • Page 7: Electrical Connection

    3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations.
  • Page 8: Precautions And General Recommendations

    PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing: • If a fault occurs, switch off the appliance and turn off the water tap. The packing box may be fully recycled as • On completion of the programme switch off the confirmed by the recycling symbol dishwasher and turn off the water tap.
  • Page 9: How To Fill The Salt Container

    HOW TO FILL THE SALT CONTAINER From a water hardness category of 1–2 (medium), before using the dishwasher, fill the salt container with regeneration salt (to find out the hardness level of water in your area, contact your local Water Board or check the last bill you received).
  • Page 10: How To Fill The Rinse Aid Dispenser

    HOW TO FILL THE RINSE AID DISPENSER The rinse aid facilitates drying and prevents the formation of unsightly spots and streaks on crockery. Before using the dishwasher for the first time, fill the rinse aid dispenser. Only use rinse aids recommended for use in domestic dishwashers.
  • Page 11: How To Fill The Detergent Dispenser

    HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. Only fill the detergent dispenser prior to starting a wash programme (see the Quick Reference Guide). 1. Press button C to open the cover. 2. How to fill the detergent dispenser. •...
  • Page 12: Care And Maintenance

    CARE AND MAINTENANCE Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. Cleaning the outside of the appliance: To clean the outside of the appliance, use a neutral detergent and a damp cloth.
  • Page 13 CARE AND MAINTENANCE Cleaning the filters 1. Rotate the microfilter counter-clockwise (in the direction of the arrow “0”) and extract it (E). 2. Remove the wide-mesh filter (F). 3. Remove the fine-mesh filter (G). 4. Clean all filters under running water, paying attention not to bend the fine-mesh filter.

Table of Contents