Kenwood NX-220 K Service Manual page 69

Item
Panel tuning mode
MSK 1) Adj item: [MSK]
Deviation Adjust: [✳✳✳.✳.]
*4 PTT: ON
Press [B] key to
[Wide 4k] store the adjust-
ment value.
[Wide 5k] 1) Adj item: [MSK]
Adjust: [✳✳.✳.✳.]
PTT: ON
Press [B] key to
store the adjust-
ment value.
12. CW ID 1) Adj item: [CWID]
Deviation Adjust: [✳✳✳✳]
*4 Deviation meter
LPF: 15kHz
[NXDN HPF: OFF
Very PTT: ON
Narrow] Press [B] key to
store the adjust-
ment value.
*4: Refer to the "Necessary Deviation adjustment item for each signaling and mode" table on page 70.
13. Battery 1) Adj item: [BATT]
Warning Adjust: [✳✳✳]
Level PTT: ON
writing
14. Battery [Panel test mode]
Warning 1) CH-Sig: 1-1
Level BATT terminal
check voltage: 6.0V while
transmitting
ADJUSTMENT (E TYPE)
Condition
PC test mode
equipment
1) Adj item: [MSK Deviation
Deviation (Analog meter
Wide 4k)] Oscilloscope
PTT: Press
[Transmit] button.
Press [Apply] but-
ton to store the
adjustment value.
1) Adj item: [MSK
Deviation (Analog
Wide 5k)]
PTT: Press
[Transmit] button.
Press [Apply] but-
ton to store the
adjustment value.
1) Adj item: [CW ID
Deviation (NXDN
Very Narrow)]
Deviation meter
LPF: 15kHz
HPF: OFF
PTT: Press
[Transmit] button.
Press [Apply] but-
ton to store the
adjustment value.
1) Adj item: [Battery Power meter
Warning Level] DVM
PTT: Press
[Transmit] button.
1) Test Channel
Channel: 1
Test Signaling
Mode: Analog
Signaling: 1
BATT terminal
voltage: 6.0V while
transmitting
Measurement
Test-
Unit Terminal Unit
Panel ANT Panel
Panel ANT
BATT
terminal
NX-220
Adjustment
Specifi cations /
Parts Method
[Panel Write the value as 2.40kHz±0.05kHz
tuning followings.
mode] 513 (Reference
Selector value)
[PC test
mode]
[ ],[ ]
3.00kHz±0.05kHz
Write the value as 1.00kHz±0.10kHz
followings.
376 (Reference
value)
Press the PTT
switch or [Transmit]
button on the PC
window.
Apply 6.20V to
battery terminal.
Confi rm that one
pre-determined nu-
meric in the range 1
to 256 appears.
[Panel tuning mode]
Press [B] key to
store the adjust-
ment value.
[PC test mode]
Press [Apply] but-
ton to store the
adjustment value.
Check The transceiver
can transmit with
causing the LED to
blink.
Remarks
69