Connecting Your Monitor : Prolite Lh4354Uhs / Prolite Lh5054Uhs / Prolite Lh5554Uhs / Prolite Lh6554Uhs - ILYAMA ProLite LH3254HS User Manual

CONNECTING YOUR MONITOR : ProLite LH4354UHS / ProLite LH5054UHS /
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer with the RS-232C Cable from the monitor.
C onnect the Power Cable to the monitor first and then to the power source.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
NOTE  Make sure that the building installation has a circuit breaker of 120/240V, 20A (maximum).
 The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
 Make sure you tighten the finger screws at each end of the Signal Cable.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
 Excessive sound pressure from ear-/headphones can cause hearing damage/hearing
loss.
[Example of Connection]
Power Cable (Accessory)
HDMI Cable (Not Included)
GAME
Equipment etc.
AV Equipment etc.
* DVI-I cable is not supplied with the monitor. If you use low quality DVI-I cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the DVI input.
22 BEFORE YOU OPERATE THE MONITOR
ProLite LH5554UHS / ProLite LH6554UHS
<Back>
HDMI Cable (Accessory)
RS-232C Cable (Accessory)
Audio Cable
(Not Included)
DVI-I Cable (Not Included)*
DisplayPort Cable
(Not Included)
Computer