Table of Contents
Advertisement
Configuration1
Adjustment Item
Switch on state
Panel saving
RS232 routing
1
Boot on source*
WOL
Configuration1 reset
Factory reset
1
*
No failover function, system will keep source even the source is no signal input.
2
*
It can be used only when SDM-S/SDM-L is installed.
Configuration 1
Switch on state
Panel saving
RS232 routing
Boot on source
WOL
Configuration1 reset
Factory reset
The monitor will turn on when the power cord is connected
Forced on
to a wall outlet.
The monitor will remain off when the power cord is
Power off
connected to a wall outlet.
The monitor will return to the previous power status (on/
Last status
off/standby) when removing and replacing the power cord.
Off
Brightness
On
For the monitor to slightly shift the position of pixels in four
directions (up, down, left or right).
Auto
Pixel shift
Off
On
Select the RS232 control port.
RS232 / LAN RS232
When the power is turned on, it starts with the same
Last input
setting as when the power was last turned off.
Off / On
Select input source when boot up.
HDMI1 / HDMI2 / HDMI3 / VGA / DVI-I / DisplayPort / SDM*
Input
/ Browser / CMS / File Manager / Media Player / PDF Player
/ Custom
Select playlist index for Browser, Mediaplayer and PDF
Playlist
player.
Off
Disable wake on LAN function.
Enable wake on LAN function.
On
Cancel
Return to Menu.
OK
Configuration1 setting will be restored to factory-preset data.
Cancel
Return to Menu.
OK
Factory-preset data is restored.
Force On
Action
RS232
Action
off
Action
Action
Problem / Option
Backlight adjustment is off.
The image brightness will be reduced to
40% of the maximum.
Move the position of the image automatically.
Pixel shift is turned off.
Move the position of the image at set
intervals. 10 - 900 seconds
OPERATING THE MONITOR 33
2
Advertisement
Table of Contents
