Table of Contents
Advertisement
REMOTE CONTROL
BATTERY INSTALLATION
1 •
Open the battery compartment cover by sliding it out.
2.
Install two (2) "AA" batteries (not included), paying attention to the
polarity diagram in the battery compartment.
3.
Replace the battery compartment cover.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1.
Use only the size and type of batteries specified.
2.
Be sure to follow the correct polarity when Installing the batteries as indicated next to the battery compartment.
Reversed batteftes may cause damage to the device.
3.
Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones,
4.
If the device is not to be used for a long period of time, remove the batteries to prevent damage or Injury from
possible battery leakage.
5.
Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
UOTBS:
• When there is an obstacle
between the DVD and the
transmitter, the transmitter may
not operate.
• When
direct
sunlight,
an
incandescent lamp, fluorescent
lamp or any other strong light
shines
on
the
REMOTE
SENSOR of the DVD, die
remote
operation
may
be
unstable.
8
Advertisement
Table of Contents
