Table of Contents
Advertisement
The addresses and data corresponding to various
parameters in the GI-10 are given below.
Address(H)Data(H)
Parameter
Description
MIDI CH
00 00 00
00
1CH
j
01
2CH
OF
16CH
BEND RANGE
000001
00
0
01
2
02
12
03
24
POLY/MONO
000002
00
MONO
01
POLY
OCTAVE SHIFT
000003
3F
DOWN
40
NORMAL
41
UP
BEND D.THIN
000004
00
OFF
01
NORMAL
02
ON
ATTACK N.FLT
000005
00
ON
01
OFF
PEDAL
ASSIGN
000006
00
MODULATION
01
EXPRESSION
TOUCH SENS
000007
00
FINGER
01
NORMAL
02
HARD
03
NO.DYNAMICS
PICKUP SENS#1
000008
00-07
1-8
#2
09
#6
OD
MASTER TUNE
O00000E
OO
440 Hz
01
442 Hz
<Example>
Setting the GI-10 MIDI transmit channel to 2
From the table, the MIDI CH address is 00 00 00H,
and the data for channel 2 is 01H. The checksum
would be 7FH, so the string is:
FO 41 10 70 12 00 00 00 02 7F F7
Sending this string from the external MIDI
sequencer will change the GI-10 MIDI transmit
channel to 2.
OUeEnvong.
Meaning of the symbols:
@: When used with a guitar with a GK-2 series
pickup.
A: When used with equipment connected to the
MIC IN jack.
@ : When used with a MIDI keyboard connected to
the MIDI IN connector.
External sound generator does not sound
@A
OA
@A
GA
Is the GK-2A volume set properly?
Try increasing the volume of the GK-2A.
@ Is the volume being reduced by the EV-5?
Try depressing the EV-5 pedal.
Is the microphone level too low?
Try increasing the microphone level.
Is the play mode set to GK?
Unless it is set to the GK mode, performance
data will not be output.
Set it to the GK mode (p. 9).
Hi Is the play mode set to MIDI IN?
Unless it is set to MIDI IN, performance
data
will not be output.
Set to the MIDI IN mode (p. 6).
Is anything connected to the MIC IN jack?
The MIC IN jack has priority, so if anything is
connected to the MIC IN jack the performance
data from GK IN will not be output.
Disconnect the plug from MIC IN.
@ Are the transmit and receive MIDI
channels
the same?
Set them to the same number (p. 9).
Advertisement
Table of Contents
