Page 1
HP F1905E SERVICE MANUAL 19〞LCD Monitor F1905E Series THESE DOCUMENTS ARE FOR REPAIR SERVICE INFORMATION ONLY. EVERY REASONABLE EFFORT HAS BEEN MADE TO ENSURE THE ACCURACY OF THIS MANUAL; WE CANNOT GUARANTEE THE ACCURACY OF THIS INFORMATION AFTER THE DATE OF...
HP F1905E 1. Product Feature 48.3 cm (19”) a-si TFT Active matrix LCD panel, 0.294mm dot pitch Scalar chipset: Genesis GM5321 Microprocessor controlled scan technology Both VGA analog and DVI-D digital signal video inputs supported 450:1 Typical Contrast Ratio and 250-nits typical Brightness...
HP F1905E 3. Operation Instructions 3.1 General Instructions Press the power button to turn the monitor on or off. The other control buttons are located on the side of the front panel. By changing these settings, the picture can be adjusted to your personal performance.
HP F1905E 3.3 Adjust the Picture Brightness Adjust the brightness. Contrast Adjust the contrast Adjust the: Auto Adjustment: Adjusts the main settings and produces a stable, centered image. Image H-Position: horizontal position of the screen image. Control V-Position: vertical position of the screen image.
HP F1905E 4. Input/Output Specification 4.1 Input Signal Connector 4.1.1 Analog D-SUB Connector MNEMONIC SIGNAL MNEMONIC SIGNAL Red Video +5 V +5 V (from PC) Green Video Sync Ground Blue Video None (Reserved for Factory Use) None DDC Data Ground (DDC Return)
HP F1905E DVI-D digital connector layout 4.2 Factory Preset Display Modes Factory Pre-set Video Input Modes Horizontal Vertical Frequency Pre-set Pixel Format Frequency (kHz) (Hz) 640 x 480 31.5 60.0 640 x 480 37.9 72.0 640 x 480 37.5 75.0 720 x 400 31.5...
HP F1905E 4.3 Power Supply Requirements PARAMETER RANGE AC Input Voltage 90 to 265V AC Input Frequency 47 to 63 Hz Inrush Current 50A MAX AT 220VAC and 30A AT 120VAC Leakage Current 5 mA MAX at 120VAC Power consumption <70W...
Page 15
HP F1905E REMARK: 1) MCU initialize. 2) Is the EEprom blank? 3) Program the EEprom by default values. 4) Get the PWM value of brightness from EEprom. 5) Is the power key pressed? 6) Clear all global flags. 7) Are the AUTO and SELECT keys pressed? 8) Enter factory mode.
HP F1905E 9. Maintainability 9.1 Equipments and Tools Requirement 1.) Multi-meter. 2.) Oscilloscope. 3.) Pattern Generator. 4.) DDC Tool with an IBM Compatible Computer. 5.) Alignment Tool. 6.) LCD Color Analyzer. 7.) Service Manual. 8.) User Manual.
HP F1905E 9.2 Trouble Shooting 9.2.1 Main Board No power No power Press power key and look if the picture is normal Please reinsert and make sure the AC of 100-240 is normal Reinsert or check the power section Measure U301 PIN2=1.8V? Measure U302 PIN2=3.3V?
Page 33
HP F1905E No picture (LED is orange) No picture 1.Check power section Measure U301 PIN2=1.8V? Measure U302 PIN2=3.3V? 2.Replace U301, U302 X201 oscillate waveforms are normal Replace X201 Check if the sync signal from computer is output and video cable is connected normally...
Page 34
HP F1905E Panel Power Circuit Measure Q402 base is high level? X201 oscillate waveforms are normal Check Q402 and Q203 Replace X201 are broken or CN401 Replace U201 Check Correspondent component. Replace PANEL...
HP F1905E 9.2.2 Power Board No Power No power Check AC line volt 110V or 220V Check AC line Check the voltage of C904(+) Check F901, bridge rectified circuit Check start voltage for the pin3 of IC901 Check R912, R916, R918, IC901...
Page 36
HP F1905E No Backlight Check CN903 Pin1/3 =12V Check adapter Check ON/OFF signal Check Interface board Check IC701 PIN6=5V+0.25V Check Q713,Q712, Q702, ZD701 circuit Check IC701 PIN1=5V Check Q707, Q706 circuit Check IC701 PIN 2 triangular wave is normal Check C720, C719, IC201 circuit...
HP F1905E 9.2.3 Keypad Board OSD is unstable or not working Is Keypad board connecting normally Connect Keypad Board Is Button Switch normally Replace Button Switch Replace Keypad Board Is Keypad board normally Check main board...
SRG color temp. parameter is x = 313±20, y = 329 ±20, Y >200 cd/m 3. Into factory mode of HP F1905E Turn on power, at the same time press the up (+) key and menu key, pull out the power cord, and then plug the power cord, Then the factory OSD will be at the left top of the panel.
Page 39
HP F1905E B. Adjust SGB color-temperature 1. Switch the chroma-7120 to RGB-Mode (with press “MODE” button ) 2. Switch the MEM .Channel to Channel 4( with up or down arrow on chroma 7120 ) 3. The LCD-indicator on chroma 7120 will show x = 313 ±10, y = 329 ±10, Y = 210 ±10 cd/m...
(Center). The exact brightness values are confirmed by the checking-regulations of different customers and different models. Ⅱ. Steps of white-balance adjustment for LCD:(Take 19” HP LCD for example) 1. Required instruments: Chroma7120、Chroma2325(BGA265A) 。 2. First connect the instruments together and turn on the LCD power, then warm up for 30 minutes under full white screen mode.
Page 41
HP F1905E d) Test white-balance again after Auto Level. Adjustment with hand is necessary if it is beyond the specs just the same. e) Select 7x00 item to adjust cool color-temperature and select 6x00 to adjust warm color- temperature. It can reach to the best effect through adjusting R/G/B value if it inclines to green or blue.
Page 42
HP F1905E 3.Input the serial number of the product (For instance: AOC LM729 is 13 bits), then press ENTER to start writing 4.Check the indication of DDC-writing program at the end. When you see the picture as the schematic picture above, “Data compare...
Page 43
HP F1905E Instruction:DDC-writing needs 4 files: Barcode.txt (Supply Barcode length and flow number) *.EXE (DDC-writing program) WR.bat (Group order file for cycling utilization of *EXE, and dual-click this file when perform DDC-writing) 4、w.dat The content with 128 bits of DDC...
HP F1905E 13. BOM List T986KAVDKHHPAP Location Part NO. for TPV Description Quantity Unit CBPC981KAVHPP CONVERSION BOARD KEPC980KB4P KEY BOARD PWPC1942AUH5P POWER BOARD 12G 423 1 BUCKET BUMPER 15G8127 1 MAIN FRAME 23G3178690 6A LOGO 34G1471CPC B BEZEL 34G1473APD 1B...
Page 46
HP F1905E 705G980KB34082 19" BACK COVER ASS'Y 705G980KP34003 19" STAND ASS'Y 750GLU90N45 Z AU 19" V50 ZBD PANEL E089A 89G402A19N LS POWER CORD AIC981KAVHPP MAIN BOARD 40G 457624 1B LABEL-CPU 40G 45762412B CBPC LABEL C201 67G305V100 7N GP KME50VB10M-CC3 5*11...