Download Print this page

M-system M6SXF2 Instruction Manual page 3

2-input math function module

Advertisement

■ CONNECTION DIAGRAM
+
1
INPUT 1
2
+
3
INPUT 2
4
JACK
CONFIGURATOR
■ WIRING INSTRUCTIONS
• Applicable wire size
Solid:
0.2 to 2.5 mm
Stranded: 0.2 to 2.5 mm
cause contact failure and therefore is not
recommended.)
Ferruled: 0.2 to 1.5 mm
• Expose wire conductors by 8 mm (0.31").
Expose 8 mm
• How to Connect Wires
5
+
OUTPUT
6
7
+
POWER
8
POWER
(0.55 to 1.75 dia.)
2
(Tinning wire ends may
2
(0.55 to 1.35 dia.)
2
Screwdriver
Wire
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
1) Insert a minus screwdriver into the wire entry opening,
between the clamp and the housing, until its tip hits the
bottom where it is firmly held.
Tension Clamp
2) Insert a wire. Push the screwdriver toward the direction
indicated with the arrow in the figure below to widen the
opening if necessary.
Wire Entry
3) Confirm that the wire tip hits the bottom and pull out the
screwdriver in holding it in position.
Confirm that the wire's insulation tube is not caught in
the clamp.
M6SXF2
Screwdriver
Wire
EM-7988 Rev.3 P. 3 / 5

Advertisement

loading