Universal Keyboard Wedge I/F Selection - PSC PSRF-1000 System Manual

Universal
Keyboard
Wedge I/F
Selection
42
To activate the Universal Keyboard Wedge interface, follow these
instructions:
1. Scan the START bar code.
2. Determine the I.D. of the terminal/keyboard. This information
is available in the Universal Keyboard Wedge Connectivity
Guide (R44-2039), or refer to the Terminal/Keyboard Settings sec-
tion below for a listing of the most common keyboard I.D.s.
3. Scan the ACTIVATE UNIVERSAL KEYBOARD WEDGE
INTERFACE bar code on the following page.
4. Using the "number pad" in Appendix B, scan in the digits for
the keyboard I.D. number you determined in step 2.
5. Scan the END bar code.
SET -------------------------------------------
Activate Universal Keyboard
Wedge Interface
Scan the digit(s) representing the desired keyboard interface type
using the Number Pad in Appendix B, then scan the END bar
code.
END ------------------------------------------
---------
PowerScan ™ RF Scanner