Table of Contents
Advertisement
200M ENTERTAINER STEREO MIXER
OWNER'S MANUAL
speakers are optional.
10. Adjust the GAIN controls to about the 12
o'clock position.
2. Set up the speakers on each side of the stage
area.
11. Set the PAN and EQ controls to about the 12
o'clock position.
3. Place the 200M in a convenient location.
12. Set the channel faders and the SUB L and
4. Plug the 200M's power cord into an ac outlet,
SUB R controls to the 0-dB setting on their
but do not turn the unit on.
scales.
5. Plug the S-200 speakers into the left and right
13. Turn up the MAIN Master slowly while
amplifier outputs.
speaking into one of the microphones until
sound is heard.
6. Set the SUB L and SUB R controls to their
lowest setting. Set all graphic equalizer controls
14. If the CLIP indicators on any channel light,
to the 0-dB mark (centered).
use a lower GAIN control setting. If the GAIN
setting is too low, turn the GAIN control up un-
7. Put the POWER AMP ASSIGN switch in the
til the CLIP indicators just begin to light, then
MAIN/MONITOR position.
turn them down slightly.
8. If condenser microphones are connected, turn
15. If feedback is experienced before a sufficient
the PHANTOM POWER switch on.
,
volume is reached, identify the frequency range
of the feedback and pull down the corre-
9. Turn the 200M on.
sponding equalizer control until it stops.
Advertisement
Table of Contents
