Table of Contents
Advertisement
The units in this manual contain a self-diagnostic function. If an error occurs, the Smart Core Red LED will automatically begin to flash.
A definition of the Smart Core Red LED flash indicators is listed in the instruction manual for the user's knowledge and reference.
If an error symptom cannot be reproduced, the remote commander can be used to review the failure occurrence data stored in memory to reveal past problems and how often these
problems occur.
DIAGNOSTIC TEST INDICATORS
When an error occurs, the Smart Core Red LED will flash a set number of times to indicate the possible cause of the problem.
If there is more than one error, the LED will identify the first of the problem areas.
Result for all of the following diagnostic items are displayed on screen.
If the screen displays a "0", no error has occurred .
RED LED blinking count
2x
3x
4x
5x
6x
7x
8x
8x
Red italic
: detect at startup sequence only.
The number of times the LED flashes translates to a probable source of the problem.
<G>: Power supply board, <B>: Main board, <T>: Tcon board, (LD) board ,
<P>: Panel module , <S>: Speaker , <A>: Power Adapter
<G/B> Main 12V over voltage [MAIN_POWER]
<B> Main 5.0V failure [DC_ALERT]
<B/S> Audio amp. protection [AUD_ERR]
<LD/P> LED driver failure/LED voltage protection [LD_ERR]
<LD/P>
Error detection of the I2C communication between the Main device and the LD IC.[BCM_ERR]
<P/T/G/B>
Panel ID EEPROM I2C No ACK (Also panel power failure is a suspect)
<T> TCon IC I2C communication error [TCON_ERR]
<G/P/B/LD> Backlight failure [BACKLIGHT]
Over temperature protection [TEMP_ERR]
<B> Temp. sensor I2C No ACK [TEMP_ERR]
<B> V By One lock error between Main device and 4KBE device [4KBE_ERR]
<B> Software error [SW_ERR]
<B> Software error [SW ERR]
Detection Items
[P_ID_ERR]
9
Advertisement
Table of Contents
