Cello 502559305 User Instructions page 5

Acuwoodslated panel

Available languages

Suojaa kuulosi!

Please use hearing protection!

CUTTING A PANEL

If you need to cut an Acuwood panel, you should use a sharp circular saw.

1. Mark the cutting line using a pencil.

2. Place the panel on a sturdy surface so that the saw blade has enough vertical

space to run through the panel along the cutting line and drop through the

panel.

3. Carefully cut through the panel along the cutting line.

4. If you can use a guide board or a similar aid, you will likely be able to achieve

a straighter cut than by cutting manually.

5. Please follow all safety precautions given by the manufacturer of the circular

saw carefully in order to cut the panel safely.

CUTTING HOLES IN THE PANELS

If you need to cut holes into the Acuwood panels for feed-throughs or e.g.

installing socket outlets, you'll also need a hole saw of a suitable size.

1. Mark the centre point of the hole carefully with a pencil. We recommend

positioning the centre point at the tongue-and-groove joint so that the hole

saw's drill is supported by it.

2. Place the panel on a sturdy surface. Make sure that there's enough space

502559305_502559304.indd 5

available in the cutting area, or that it has a covering that the saw can hit

safely.

3. Drill firmly all the way through the panel at a straight line, using as fast a

rotation setting as possible.

4. Please note: If the hole you intend to cut is small, at most 20 mm, it should

be made in between the tongue-and-groove joint.

PANEL SPACING

When you are setting a panel in place next to another panel, align them as

shown in the image.

13.4.2023 9.19

502559304