Table of Contents
Advertisement
Chapter 3 Basic Operations
Playback
12
Rear side of a cassette
Basic Operations
This saction shows you how to play back a video cassette
Inserting a Video Cassette
1 Insert a video cassette with the window facing up.
2 Gently press the center of the front side of the cassette until the mechanism draws
it into the compartment
When the cassette has been inserted, the cassette indicator
display window and the VCR turns on automatically.
lights up in the
Ejecting
the Video Cassette
Press 4 EJECT on the VCR. You can eject the cassette when the power is off.
When you press # EJECT, the power is turned on. After ejecting the cassette, the
power automatically shuts off.
Note
You cannot eject a cassette during recording or recording pause mode.
Cassette Care
Notes
* Always insert the cassette in the correct position
* Never insert anything in the smail holes on the rear of the cassette.
* Store cassettes in their cases and keep them in an upright position to prevent
intrusion of dust and uneven winding.
*
To record from the beginning of the tape, run the VCR for about 15 seconds at the
beginning of a cassette before recording
« When the VCR is not in use, remove the cassette.
* Stick the cassette label in the designated area.
* Stick the label on securely so it will not peel off and damage the VCR
Maximum recording time of a cassette
Cassette used
Recording/Playback Time
Piayback Time
(SP mode)
(LP mode)
[E6630
|
30min
1h
E6/P6-60
lth
o e
lpehe
| P6-90
Th 30 min
3h
E6/P6-120
2h
| 4h
P6-150
3h 30 min
3h
This VCR automatically detects the type of the tape speed mode (SP or LP) in which
the tape has been recorded, and plays it back acccordingly.
The picture quality recorded in the LP mode is inferior to one recorded in the SP
mode
:
Protecting a recording against accidental erasure
To prevent accidental erasure, slide out the tab on the back of the cassette so that the
red color is visible.
To re-record on the cassette, slide the tab back.
@ EJECT
QUAL MODE
SHUTTLE ring
Never unplug the AC power cord
while » tape is moving
This may cause the tape to be
jammed in the VCR. When you need
to unplug the power cord, be sure to
remove the cassette or turn off the
power of the VCR.
Note
* When you play back a cassette
recorded SAP broadcast, you can
not hear the main sound but the
SAP sound.
Playing Back a Cassette
panel lights up.
2 Turn on the TV.
If your TV is connected to both VHF/UHF OUT and LINE OUT on the VCR, select
the input for the VCR.
It your TV is connected only to VHF/UHF OUT on the VCR, select the preset
channet for the VCR (Ch 3 or Ch 4).
3 Press ® PLAY.
To stop playback
Press @ STOP.
To stop playback for a moment
Press tt PAUSE.
Press It PAUSE again or press ® PLAY to resume playback.
To rewind the tape without viewing pictures (rewind mode)
VCR: Press @ STOP, then tum the DUAL MODE SHUTTLE ring counterclockwise.
Remote Commander: Press B STOP, then 44 REW.
To eject the cassette
Press & EJECT on the VCR.
When the tape reaches the end during playback
The VCR automatically rewinds the tape to the beginning and the power
remains on.
To turn the VCR on or off
Press POWER.
Basic Operations
13
Advertisement
Table of Contents
