Advertisement
CARE AND MAINTENANCE
AWARNINGo Befocc ettempting to pe;lonn eny maintenance on this unit, tum ell
controls to
the "OFF" position and unplug. Allow the unit to be "OFF" for at least 10 minutes before any
maintenance applied in order to allow all components to cool down properly.
Cleaning:
1. To remove dust, fingerprints
or
other marks from glass window, use clean damp cloth. Do not
spray glass cleaner or other liquid directly onto the glass.
2. Clean metal surtilces with a clean damp cloth making sure not to push dust or debris into any
air intake or exhaust vents.
3. Do not usc abrasive cleansers or spray liquids on any part of the appliance.
4. Periodic cleaning vacuuming of the fan/heater unit is strongly recommended to ensure that no
diti or foreign objects build up.
Replacing Remote Control Battery
If the remote controls stops functioning or operate poorly, the battery should be replaced with new
one (model# CR2025).
1. The battery compartment can be found on the back side of the remote control.
2. Press and slide the batteJy door to open and remove the old battery.
3. fnscri a new CR2025 coin battery, making sure that the polarity"+" and"-" atchcs properly as
Illustration showing.
4. Close the battery door.
Warning:
Like with any remote control unit, the remote control unit included with your fireplace may
unwantedly affect or control other electric products such as TVs. If this occurs, you can change
the encryption on your fireplace remote so that it will not affect other products. To change the
settings on your fireplace remote, hold down the Timer button on the fireplace remote for 3
seconds. To test, use your fireplace remote and see if your other products are still affected.
[f
so,
you may change your fireplace remote to a third encryption by again holding down the Timer
button on the remote for 3 seconds. To test this third encryption setting, use your fireplace remote
and see if your other products are still affected. To get back to the original encryption setting, hold
down the Timer button on the fireplace remote for 3 seconds.
Zero Clearance Fireplace
The electric fireplace has zero clearance safety technology, with the advanced zero clearance
safety sensor, if there is something covering or closing the slide outs, after about 20 seconds,
the appliance will switch off power automatically. Then pull the plug out, Let the appliance
cool down for 3 minutes, Plug the power cord again, the fireplace will be working again.
Advertisement
