Table of Contents
Advertisement
Before Operation
Setting the Clock
Press CLOCK.
1 1
(If the clock requires setting, press and hold CLOCK
for more than 2 seconds.)
- The hours display begins to blink.
.
Select either the 12 hour cycle or the 24 hour
2 2
cycle by turning MULTI JOG. shuttle.
or
(12HR)
Press SET/CD [] to confirm the selected hour
3 3
cycle.
Use MULTI JOG. shuttle to set the current hour.
4 4
Press SET/CD [] .
5 5
.
Use MULTI JOG. shuttle to set current
6 6
minutes.
Press SET/CD [] and the correct time is shown
7 7
on the display.
Notes
Notes
When the clock is not appeared in the display
window, follow as below.
• In case the clock is set, press the CLOCK button.
The clock will be shown in the display window for
about 5 seconds.
• In case the clock is not set, the clock will blink in the
display window for about 1 minute. Set the clock as
above.
Sleep Timer Function
When the sleep timer is set, the unit automatically turns
off after the specified time has elapsed.
To specify the time delay before the power is
1 1
turned off, press SLEEP.
In the display window you can see SLEEP 180 for
about 5 seconds. This means that the system turns
off automatically after 180 minutes.
Each time you press SLEEP the setting changes
2 2
in the following order.
SLEEP 180 →150 → 120 →90→80→70 → 60→ 50 →
40 → 30 → 20 →10 → OFF (No display) →SLEEP 180...
To check the remaining time until the power is
3 3
turned off.
While the sleep function is active, press SLEEP
briefly.The remaining until the unit is turns off, is
displayed for about 5 seconds.
Note
Note
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the SLEEP button
repeatedly until "SLEEP 10 " appears, and then press
SLEEP once again after "SLEEP 10 " shows on the
display.
Using Microphone - OPTIONAL
You can sing to a music source by connecting a
microphone to the unit.
1 1
(24HR)
2 2
3 3
For your reference
You can record using microphone.
Refer to the "Recording" explanation section.
Notes
Notes
• When not using the microphone, set the MIC VOL.
• If the microphone is set too near the speaker, a
• If sound through the microphone is extremely loud, it
To Adjust ECHO Volume
You can give an echo effect to the sound from the
microphones.
Press the ECHO VOL. (
increase the echo volume or decrease it.
(MIN,1 - 14, MAX steps)
Connect your microphone to the
MIC1/ MIC 2 Jacks.
"
" will be shown in the display window.
Play a music you want.
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOL. knob. (MIN,1 - 14, MAX steps)
knob to minimum or turn off the MICs and remove the
microphone from the MIC jacks.
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC VOL. control.
may be distorted. In this case, turn the MIC VOL.
control toward minimum.
/
) on the remote control to
11
Advertisement
Table of Contents
