Casio PB-100 Instruction Manual page 61

• D a t a c a i l o u t
Format: GET ("filename"] variable 1 [.variable 2]
(Items in brackets may be omitted.)
«
This command can be used both manually and by writing it in a program.
For manual use, start the tape recorder in the PLAYBACK position and operate as
. f o l l o w s .
GET ("filename"] variable 1 [.variable 2] S3
For use in a program, write it with a line number attached and start the program.
• Checking of the file which has been recorded on the tape
A VER command is used to check whether the programs or data have been recorded
p r o p e r l y.
Format: VER ("filename"] (Item in brackets may be omitted.)
The operation sequence is similar to program load.
■ P r i n t e r
An exclusive mini printer can be connected to the PB-100. By connecting this printer,
program lists or data can be extracted. Also, the output of calculation results during
execution can be printed out.
For printer connection procedures and operating procedures, refer to the mini printer
operation manual.
To print a program list, press ® CZ) and designate the PRT mode.
Program list
S ^ ( S 1 @ ( Z )
LIST m or LIST A SS
®(S) (PRT mode release)
After printout is complete, be sure to press ® (g) and release the PRT mode.
Also, to print calculation results or operation contents, printout can be performed
automatically by writing "MODE 7" and "MODE 8" in the program.
Example:
1 0 0 M O D E 7
1 1 0 P R I N T A
1 2 0 M O D E 8
When "MODE 7" is written in the program, be sure to write "MODE 8" prior to
program termination and release the PRT mode.
- 6 0 -