Table of Contents
Advertisement
If the VOX feature is enabled, audio playback through channels 2-5 will be reduced in volume automatically when speaking into
MIC 1, use its attenuator to increase or decrease the mute level.
In addition to channel and MASTER volume controls, there are BASS and TREBLE EQ controls to adjust the tone of the overall
output. At the 12 o'clock position, these controls are applying no effect to the signal (no boost or cut). Moving the BASS control
clockwise boosts the low frequencies in the audio, whilst moving it anticlockwise will cut these low frequencies. Likewise,
moving the TREBLE control clockwise boosts the high frequencies in the audio, whilst moving it anticlockwise will cut these
high frequencies. Adjust these EQ controls to suit the type of audio signal or compensate for the room acoustics.
Media Player
The built-in media player includes MP3/Bluetooth/FM/DAB+ functionality. Press the Mode button to switch between the sources
MP3/Bluetooth/FM/DAB+. The LED display shows the current source. The IR remote can also be used to control the media player
up to a distance of 10 to 30m.
Holding the Previous track or Next track buttons will adjust the output volume of the media player.
Bluetooth
The Bluetooth function can be used to use a smart phone or tablet for playback of stored files or streaming audio. In order to
use this function, it is necessary to pair the sending device and the receiver. Follow the next steps:
1. Press the "Mode" button on the Media player to select "Bluetooth" to activate Bluetooth, the receiver becomes visable and is
ready to pair.
2. Open the Bluetooth settings menu on the smart phone or tablet (or other sending device).
3. Scan for Bluetooth devices and look for it in the list of available devices.
4. Select the amplifier, the sending device should confirm that it is now connected as an audio device.
5. Play audio from the sending device, ensuring that volume controls are not turned down/muted.
6. Turn up the Master volume on the amplifier to the required level.
If the Bluetooth signal is lost, it may be necessary to re-select the Bluetooth on the sending device.
The Previous, Next and Play/pause buttons will operate in Bluetooth as remote playback controls.
USB/SD Playback
Push a USB pen drive into the USB port and/or an SD card into the SD card input.
Press the CD/USB/SD button to ensure that the player is set to play from the required memory device. Press the PLAY/PAUSE
button to play the current track and press again to pause as needed.
Searching and playback of tracks is the same as described above for the CD player.
FM Tuner
Press the FM select button to switch to the FM tuner function. Use the Previous or Next buttons to select a stored channel.
Tuning and storing stations
Use the Forward/Reverse seek buttons to manually tune the frequency in steps of 0.05MHz.
1.
TF card input
2.
LED display
3.
IR sensor
4.
USB input
5.
Mode to select MP3/BL/DAB+/FM
6.
Play
7.
Folder
8.
RPT repeat
9.
Previous & volume- decrease
10. Next & volume + increase
7 /
11
Advertisement
Table of Contents
