Panasonic WV-BL730 Operating Instructions Manual page 23

1. Move the cursor to the ALC/ELC parameter.
2. Select ALC or ELC.
Cautions:
1. Under bright lighting conditions such as outdoors,
use an ALC type lens because the ELC control
range is not wide enough under these conditions.
2. Use an ALC type lens if phenomena below occur:
• Strong smear and/or blooming on highlight
objects such as spotlight or sunlight from win¬
dows.
• Noticeable flicker in the picture and/or color
rendition variations.
3. If ELC is selected, ALC and SHUTTER is not avail¬
able.
Back Light Compensation (BACK LIGHT COMP)
Back light compensation is available for both the ALC
and ELC modes. It eliminates by strong background
lighting which makes the camera picture dark, such as
a spotlight. You can select one of two modes (PRESET
ON or PRESET OFF) of back light compensation.
2-1. ALC Mode with PRESET ON
In normal use, the important object in a scene is
placed in the center of the monitor's screen. In the fac¬
tory setup mode, more photometric weight is given to
the center of the screen (where the important object is
located) than to the edge of the picture (where a bright
back light would most likely be located). In this mode,
even though the backlight may vary, the object at the
center of the screen can be still be clearly seen.
Note: If ELC is selected, set LEVEL according to this
procedure.
** CAB SET TO **
CAMERA ID OFF 1
ALC/ELC
ALC n
SHUTTER
OFF
AGC ON
SENS DP
OFF
SYNC HIT
MOTION DET OFF n
LENS DRIVE DC
END SET DP ENABLE
\_-_/
1. Press [=□ after selecting ALC, the ALC CONT
menu appears.
-
21
-