Connections - soundsation MOOD L100 BEAM User Manual

ENGLISH
of the installation material used, and periodic safety inspection of it
and the projector. If you lack these qualifications, do not attempt the
installation yourself, but instead consult a professional structural
rigger. Improper installation can result in bodily injury or property
loss.
If the fixture shall be lowered from the ceiling or high joists, professional trus-
sing systems have to be used. The fixture must never be fixed swinging freely
in the room. Before rigging make sure that the installation area can hold a
minimum point load of 10 times the projector's weight.
CAUTION: Fixture may cause severe injuries when crashing down. If
you have doubts concerning the safety of a possible installation, do
not install the fixture!
CAUTION: Use two appropriate clamps to rig the fixture on the truss.
Follow the instructions mentioned at the bottom of the base. Make
sure that the device is fixed properly! Ensure that the structure
(truss) to which you are attaching the fixtures is secure.
DANGER OF FIRE! When installing the device, make sure there is
no highly inflammable material (decoration articles, etc.) within a
distance of minimum 0.5 metre.
The moving-head light can be placed directly on the floor or rigged in any
orientation on a truss without altering its operation characteristics. Use the
rigging clamp to merge the M10 or M12 screw – please check the base.

3.2. Connections

3.2.1 Mains Connections
Connect the device to the mains with the power-plug. The wire corresponden-
ce is as follow:
The earth must to be connected! Pay attention to the safety!
10
Cable
Brown
Blue Neutral
Yellow/Green
MOOD L100 beam User manual
Pin Intermational
Live L
N
Earth