Mitsubishi Electric CITY MULTI PLFY-WL-NEMU-E Series Operation Manual page 12

3. Operation
<Ventilation setting>
Fri
Low
Vent.
F1 F2 F3 F4
RETURN SELECT
MENU
OFF
HOLD
<Returning to the Operation menu>
Operation
Vane·Louver·Vent. (Lossnay)
High power
Comfort
Main menu: RETURN
Cursor
F1 F2 F3 F4
RETURN SELECT
MENU
OFF
HOLD
Notes:
●
During swing operation, the directional indication on the screen
does not change in sync with the directional vanes on the unit.
● Available directions depend on the type of unit connected.
● In the following cases, the actual air direction will diff er from the
direction indicated on the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. Immediately after starting heat mode (while the system is wait-
ing for the mode change to take eff ect).
3. In heat mode, when room temperature is higher than the tem-
perature setting.
en
10
Press the [F3] button to go through
the ventilation setting options in the
order of "Off ", "Low", and "High".
* Settable only when Lossnay unit is
connected.
Off Low
Off Low
• The fan on some models of indoor
ON
units may be interlocked with certain
models of ventilation units.
Press the [RETURN] button to go
back to the Operation menu.
ON
< How to set the fi xed up/down air direction (Only for
wired remote controller) >
Note:
●
This function cannot be set depending on the outdoor unit to be
connected.
• For PLFY-WL·NEMU-E series, only the particular outlet can be fi xed
High
High
to certain direction with the procedures below. Once fi xed, only the
set outlet is fi xed every time air conditioner is turned on. (Other outlets
follow UP/DOWN air direction setting of remote controller.)
■
Explanation of word
• "Refrigerant address No." and "Unit No." are the numbers given to
each air conditioner.
• "Outlet No." is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
• "Up/Down air direction" is the direction (angle) to fi x.
Reset
Horizontal airfl ow
Remote controller setting
The airfl ow direction of this outlet
is controlled by the airfl ow direc-
tion setting of remote controller.
Outlet No. 2
Outlet No. 1
Note:
The outlet No. is indicated by the number of grooves on both
ends of each air outlet. Set the air direction while checking the
information shown on the remote controller display.
1 2 3 4
horizontal
Downward
Fixed
The airfl ow direction of this outlet is fi xed
in particular direction.
* When it is cold because of direct air-
fl ow, the airfl ow direction can be fi xed
horizontally to avoid direct airfl ow.
Outlet No. 3
Outlet No. 4
Air outlet identifi cation marks
5
MITSUBISHI
ELECTRIC
label